Another video on Metal Roof leak Repair – https://youtu.be/gVdrrfe_lBY
This video will help you understand why metal roofs leak and How to seal the screws. The cleaning and preparation is the most important part.
Steps on Fixing leaks on a Metal Roof:
1. Remove all the old Tar, caulking, and Tape from the screws and seams
2. Use an angle grinder with a metal wire brush attached to clean up every seam and screw
3. If necessary, use Lacquer Thinners with a rag to remove any silicone residues
4. Apply 1 coat of Turbo Poly Seal over the seams
5. Place the Polyester Fleece into the wet Turbo Poly Seal
6. Apply a final coat of Turbo covering the fleece.
7. Wait 24 hours and then paint a Silver Coat Protection over the Turbo.
Silver Coat Protection – https://bergstromm.com/product/silver-coat-1-quart/
Turbo Poly Seal – https://bergstromm.com/product/turbo-poly-seal-1-gal-50-ft-fleece/
0:00 Before Installing Solar Panels
0:42 Using Torch removing Tar, Caulking
2:00 Using Grinder to prepare the surface
2:49 Theory why metal seam leaks
4:18 Using Turbo Poly Seal over screws
5:40 Using Oil Based primer
7:20 The End Bla Bla Bla