The most common problem on any roof is the flashing that causes roof leaks. Turbo Poly Seal is the go-to sealant I use to repair leaking roofs. Expensive homes are not immune to it.
After many roofing contractors failed to repair this roof leak, see how easy it was to find and fix it.
Go to https://bergstomm.com to get this product.
https://flatroofdoc.com/flat-roof-repairs-flashing-greenwich/
Anytime a metal flashing is attached to a wall by inserting it into a grove, it is likely to leak.
This is a common problem on all flat roofs with brick chimneys, brick walls.
The method to install counter flashing on a brick wall and seal it with caulking in the slotted grove has always failed.
The solution to this problem is Turbo Poly Seal. The idea is to make a transition from the brick wall to the metal that would last a long time.
Steps to repairing flashing leaks:
1. Clean and remove all caulking and tapes that were used previously
2. Tape of the three inches above and below the transition area
3. Apply one coat of Turbo Poly Seal between the taped off areas covering the transition seam area
4. Install the Polyester Fleece over the freshly painted Turbo Poly Seal
5. Apply a final coat of Turbo Poly Seal covering the Polyester fleece
6. Remove the masking tape immediately after finishing the final coat
0:00 Identifying the cause of the leak
1:37 Masking Tape
2:00 1st coat Turbo Poly Seal
2:22 Embedding fleece
2:53 2nd Coat Turbo Poly Seal
4:12 Removing Turbo Poly Seal
5:07 Showing results around vent pipe
5:46 End