See how to make a Transition from Metal to EPDM Rubber.
This video is about How to Repair a Metal Roof Leak Repair that ends on a flat rubber roof. Most of the time these transitions from Metal to rubber leak and are very difficult to seal. I show you step by step how to do this repair and a list of tools and materials needed.
You can find Super Silicone here: https://bergstromm.com/
Chapters:
0:00 Metal Seam Leak Repair
0:15 Tools and material
0:56 What went wrong?
1:34 How to remove tar/caulking
3:25 My joke to make you laugh
5:52 Applying Super Silicone Seal
8:14 Showing 2-month-old repair
General Instructions on how to Fix Leaks on a Metal and Rubber Roof:
1. Locate the leaky area. Either a seam or some flashing are the most common causes for leaks
2. Remove all the caulking, tar, and tapes people have used to attempt repairs
3. Use an angle grinder with a stiff wire brush to remove any silicone or tar and to smooth out the surface
4. Take a rag and dose it with Lacquer Thinners to clean the surface of the area to be repaired
5. Use masking tape to tape off the area where you want to make the repair
6. Apply 1 thick coat of Super Silicone Seal or Super Silicone Seal over the seam or approximately 5″ wide
7. Embed the Polyester Fleece into the coating
8. Apply a top coat of Super Silicone Seal or Super Silicone Seal over the Polyester Fleece. make sure to cover the fleece completely.
List of Tools and materials needed to make the repair:
1. Estwing Flat bar – to remove heavy tar and caulking
2. Angle Grinder
Wire Brush
3. Lacquer Thinners
4. Rags
5. Masking Tape
6. Protective eyeglasses
7. Scissors
8. Leaf Blower or Broom
9. Super Silicone or Super Silicone Seal – https://bergstromm.com/