RV Motorhome and Mobile Homes Roofs Sealed and Repair -Altoona, PA
Mobile Home Roofs are notorious for leaking. Some roofs are slanted, some are round, and some are completely flat. Whichever roof you have, I am here to help you fix any leak on your RV, Motorhome, and Mobile Home. Altoona
Transition Flashing on Mobile Home Roofs
The most common source of leaks occurs where a carport or room is attached to a mobile home. The transition between these two structures is challenging to seal properly and often results in leaks.
In this video, we demonstrate how to correctly make that transition from a room or carport to the main roof.
There are over 12,000 Mobile homes in and around Altoona.
We also demonstrate how to use a rubber membrane to cover part of the roof.
Turbo Poly Seal is the recommended Product for the transition between metal and asphalt rubber Roofs.
Mobile Home Roof/ Camper/ RV Motor Home Complete Roof Seal
Proper Preparation for Resealing an RV Motor Home, Camper, or Mobile Home Roof, Altoona, PA
When it’s time to reseal your RV, camper, or mobile home roof, preparation is the most crucial step to ensure a long-lasting seal.
Step 1: Remove Old Caulking
Start by removing all previously applied caulking—especially around vents, seams, and any other roof obstacles. This is critical, as leftover silicone can interfere with the new sealant.
Step 2: Clean the Roof Thoroughly
Next, clean the entire roof using lacquer thinner. This step is important because when using an angle grinder, the heat from the bristles can melt old silicone caulking and smear it across the surface. Once smeared, the silicone can prevent the new sealant from properly bonding to the roof.
Step 3: Apply Super Silicone Seal
After cleaning, use a 2-inch disposable paintbrush to apply Super Silicone Seal around detailed areas such as vents and seams. Then, use a 9-inch roller with a 1/4-inch nap to evenly coat the entire roof surface.
Step 4: Reinforce Transitions with Polyester Fleece
For any transition areas—like where a vent, skylight, or flashing meets the roof—you must use polyester fleece, as shown in the video. This adds strength and flexibility to those vulnerable spots and helps prevent future leaks.
How to Repair shingles on a Mobile Home
6 Steps on how to Repair shingles on a Mobile Home
If you have shingles that start to cause leaks, this video will help you repair the shingle roof and buy you much needed time before you have to repalce the roof.
Shingle Roof Repair Instructions (Mobile Home)
Step1: Purchase Materials – Get a roll of Liberty Peel & Stick roofing membrane from Home Depot.
Step 2: Measure & Cut – Measure the section of roof to be covered, then cut the membrane to the needed length.
Step 3: Install Drip Edge – At the lower edge of the roof, nail in a new drip edge to help direct water away from the structure.
Step 4: Position First Membrane – Lay the Liberty Peel & Stick membrane over the drip edge.
Step 5: Adhere Membrane – Remove the release liner from the underside of the membrane, pressing it firmly into place.
Step 6: Continue Up the Roof – Overlap the next piece of membrane with the first, making sure it adheres tightly. Repeat until you reach the roof’s peak.
Products and Instructions to use for each type of Flat Roof Leak Repair
Modified Bitumen Rubber Roof Leak repair
When making repairs on these type of roofs, Turbo Poly Seal should be used. Turbo Poly Seal has asphalt properties that makes it compatible with Modified Bitumen. How to use Turbo Poly Seal for a Roof Repair
- 1. Determine what is causing the leak. That could be a seam, vent pipe and or flashing
- 2. Clean the area of repair thoroughly. Use water and a rag to wash all debris off.
- 3. Make sure the surface is dry and clean. There should be no old tar, caulking and other repair materials
- 4. Open the Turbo Poly Seal Container and stir the content well.
- 5. Use a 2" disposable brush, and apply 1 thick coat over the area of repair. Make sure to allow at least 2 inches of sealant on either side of the area that need to be sealed.
- 6. Cut the appropriate length of Polyester Fleece and embed it into the freshly painted surface.
- 7. Apply another coating covering the entire fleece. Make sure the fleece is not exposed
EPDM Rubber and TPO Vinyl Roof Leak Repair
Repairs on these type of roofs should only be made with Super Silicone Seal. This is the only product that adheres to EPDM Rubber. TPO can be repaired with either product, Turbo Poly Seal or Super Silicone Seal
- 1. Determine what is causing the leak. Most leaks on a EPDM Roof stems from T joints of seams around curbs and skylights.
- 2. Clean the area of repair thoroughly. Use water and a rag to wash all debris off.
- 3. Make sure the surface is dry and clean. There should be no old tar, caulking, tapes and other repair materials
- 4. Open the Super Silicone Seal Container and stir the content well.
- 5. Use a 2" disposable brush, and apply 1 thick coat over the area of repair. Make sure to allow at least 2 inches of sealant on either side of the area that need to be sealed.
- 6. Cut the appropriate length of Polyester Fleece and embed it into the freshly painted surface.
- 7. Apply another coating covering the entire fleece. Make sure the fleece is not exposed
Metal Roof leak Repair
Metal Roofs can leak at the seams and or the fasteners. It is important to torque the screws down before applying any sealant. When repairing leaks on a metal roof, we suggest to use Super Silicone Seal. Turbo Poly Seal can be used in most cases.. Follow the steps below to make the repairs.
- 1. Most likely a seam or fastener is causing the leak. After tightening the screws down, proceed with the repair.
- 2. Use an angle grinder with a steel brush to remove rust, debris and old repair materials like caulking and tar.
- 3. Make sure the surface is dry and clean. There should be no old tar, caulking, tapes and other repair materials
- 4. Open the Super Silicone Seal Container and stir the content well.
- 5. When sealing a seam, apply a coat of sealant 2 inches wide on either side of the seam. Embed the Polyester fleece into the sealant. Avoid embedding the fleece over screws.
- 6. Apply another coat over the fleece covering it entirely.
- 7. After tightening the screws, dab the screw heads with Super Silicone Seal making sure the sealant covers the entire surface around the screw. No fleece should be used over the screws
About Us
Bergstrom Industries
We have been in business for over 40 years. We provide high-quality roof sealants to commercial and residential clients.
Besides the products we sell, we will also come and inspect your roof, train 2 of your employees if necessary, to maintain your roof.
Why Choose Bergstrom Industries for Quality Repair Products
Bergstrom Industries is a trusted name for Altoona, PA’s best flat roof repair products. Our top-quality repair products have helped many customers extend the lifespan of their roofs. Moreover, our flat roof repair products are designed to last as long as your roof does.
It is important to get the leaks fixed in time
The rainy season can cause your roof to drip like an uncapped faucet. Therefor, instead of damaging your roof by allowing the leaks to persist. Choose the finest flat roof waterproofing products from Bergstrom Industries and rid yourself of leaky roofs.
As a top product online roofing store for Altoona, PA, we offer quality roof repair products at the most affordable prices. Our waterproofing products, like SUPER SILICONE SEAL and TURBO POLY SEAL have helped numerous customers fix their roofs.
Click on the product link above to see all the products we offer.
Select from the following YouTube Videos on How to repair Metal and Flat Roof leaks in Altoona
By watching these videos, you will gain a good understanding of what to do and how to approach repairing leaks on your roof.
Services
The methods described above and in the videos have been tested over a period of 18 years
Contact Us
How to Repair and Seal Leaks on a RV Motor Home and Mobile Homes in Altoona, PA
Find Us
Get information
Tel # 203 858 0080
See if you are the lucky one:
Send a Text with your name and address, including pictures of your RV or Mobile home that needs roof work.
Send to 203 858 0080
We prefer those that are within 3 hour drive from Mt Pleasant, PA
We will select a few and contact you to come and fix the problem for FREE
Add Your Heading Text Here
© 2021 All Rights Reserved.